You may have experience your Latitude 5289/7389/7390 2 in 1 system overheating, shutting down unexpectedly or displaying a fan always on issue in daily usage (may be perceived as fan noise). Is there any way I can disable this F1 process? Just to be sure: The Xtreme Gaming Engine says that the fan rpm is locked at zero, even when setting custom fan … The Silent / Stop LED light off means fan does work. The Silent / Stop LED light on means fan doesn’t work. For example, let’s say the temperature of what’s being cooled by the fan is 100C. The card runs fine, great even, but I don't want to run this thing without cooling. I've changed the CPU casing (tower) for a better air vent and to avoid overheating because I used it excessively. 3. It depends on the BIOS, on the temperature of whatever is being cooled by the fan, and potentially on other settings. And so this results in a never-ending loop of clinking noises that quickly becomes highly annoying (especially in a quiet room) due to the GPU constantly powering up/powering down its fans. So if you wanted to be in complete control and always stop them right after exiting AI Suite II, then go into Services.msc, right-click the two services we set to "manual", and then choose "Stop". Looking at the article you linked: 1. ive noticed recently my engine/coolant fan is always runing. Fan Control in Windows 10 With a Fan Controller . Hello, I have just installed ai suite 3 that came with the extreme vi motherboard on windows 8 but it has installed an annoying desktop gadget that I m not planning to use at the bottom right of the screen. Fan stop working during the GPU in low temperature, the working standard as below: GPU temp lower than 62℃, fan will stop working to save energy and reduce the noise. Most fan controllers require an available slot in … Coolant is not low, is not overheating, I do have a 180t stat, never gets warmer then 170-190. My card's fans are not spinning, and the 'Fan Stop' LED is on constantly, even while the card is under load. Graphics driver. Cases like NZXT's H-series i versions have a built-in link box which gives you software control over your CPU fan in much the same way as Speedfan, but in a more intuitive manner. I have tried to look in the various tab but couldnt find an option to disable this, is there anyway to remove this gadget without uninstalling the suite? Power saver plan enabled, no change in fan speed. If you want more control over your CPU fan and other aspects of your system, a fan controller is a good bet. I can't see any option for "Fan always on" in the BIOS. Make sure the fan controller you purchase is able to support all the fans in your computer and has the appropriate pin connectors. You can purchase a fan controller online or from a computer store. 4. Vents are clear, this is a new computer. So I have no idea idea why it always is running it seems. Purchase a fan controller. A few seconds later though, the fans switch off because they've managed to swiftly reduce the temperature of the GPU to the high 50's. GPU temp higher than 63℃, fan will start working for cooling. Dell 7490, fresh Windows install. Thanks. Update BIOS. 2. Fortunately, they do not automatically start with Windows! This computer has no graphics fan. Note: every single process that gets started by these two services will continue running even after completely exiting AI Suite II. Oct 18, 2017 at 7:47 AM #2. kiloRAM Senior Member. WavesSysSvc Service Application is running at 25-30% and the fan on the PC is constantly running. but after the casing has been replaced, I need to press F1 everytime I use the computer. Its cold here (in MASS) so any ideas? Posts: 202 The BIOS is AMI 2.17.1249. Cleaning vents. Thanks!